enphase IQ8X - IQ8 HC-72-M-US Microinverter Specifications

IQ8MC, IQ8AC, IQ8HC, and IQ8X Microinverters Installation and Operation Manual
34 © 2023 Enphase Energy Inc. All rights reserved. November 2023
USM-00008-2.0
IQ8HC-72-M-US Microinverter specifications
Enphase IQ8HC-72-M-US Microinverter parameters
Topic Unit Minimum Typical Maximum
DC parameters
Commonly used modules for pairing
1
W 295–540
Module compatibility
To meet compatibility, PV modules must be within the
following maximum input DC voltage and maximum module Isc
Module compatibility can be checked at
https://enphase.com/installers/microinverters/calculator
.
MPPT voltage range V 29.5 45
Operating Range
V
18 58
Minimum/Maximum start voltage
V
22 58
Maximum Input DC Voltage V 60
Max. continuous operating DC current A 14
Max. input DC short-circuit current A 25
Max. module I
sc
A 20
Overvoltage class DC port II
DC port backfeed under single fault A 0
PV array configuration
Ungrounded array; No additional DC side protection
required; AC side protection requires max 20 A per branch
circuit
AC parameters
Peak output power
240 VAC
208 VAC
VA 384
366
Maximum continuous AC output power
240 VAC
208 VAC
VA
380
360
Nominal grid voltage (L-L)
240 VAC
208 VAC
V
split-phase (L-L), 180°
single-phase (L-L), 120°
Minimum and Maximum grid voltage
2
240 VAC
208 VAC
V 211
183
264
229
Max continuous output current
240 VAC
208 VAC
A
1.58
1.73
Nominal frequency Hz 60
Extended frequency range Hz 47 68
AC short circuit fault current over 3 cycles
A
rms
2.70
Maximum microinverters per 20 A (max) AC
branch circuit
3
240 VAC
208 VAC
10
9
Total harmonic distortion
% <5
Overvoltage class AC port III
AC port backfeed current mA 18
Power factor setting 1.0
Grid-tied power factor (adjustable) 0.85 leading … 0.85 lagging