Preface
Instruction manual 862 MIT Page 3
Preface
This manual is intended for technicians involved with the commissioning and service of the Enraf Series
862 Multi element Interface Thermo sensor converter, connected to Enraf series 854 level gauges,
873 SmartRadar or 877 FDI.
For mechanical and electrical installation of the 862 MIT and the 864 MTT (Multi Thermo sensor Thermometer),
refer to the installation guides of these instruments. Refer also to the list of related documents in Appendix B.
A description preceding the technical procedures gives the technical information necessary to understand its
functioning. It is recommended to read this description prior to performing any of the procedures.
Safety and prevention of damage
Refer to the safety chapter in the instruction manual and installation guide of the related instrument for the safety
aspects of the instrument and for personal safety and safety conventions.
EC declaration of conformity
This instrument is in conformity with the protection requirements of EC Council Directive 89/336/EEC.
The CE conformity marking fulfills the provisions of
EN 50081-2 Generic Emission Standard
EN 50082-2 Generic Immunity Standard
73/23EEC Low Voltage Directive
when installed, maintained and applied according to requirements as specified in this manual.
Legal aspects
The information in this manual is the copyright property of Enraf B.V., Netherlands.
Enraf B.V. disclaims any responsibility for personal injury or damage to equipment caused by:
• Deviation from any of the prescribed procedures;
• Execution of activities that are not prescribed;
• Neglect of the general safety precautions for handling tools, use of electricity and microwave radiation.
Additional information
Please do not hesitate to contact Enraf or its representative if you require additional information.
To Next Page
Loading...