Enso PGT - Installation Guide; Assembly Steps

—5—
FOR Service or Questions Call 1-844-395-4587
Installation Guide
STEP
Two people are
required to assemble
this adjustable base.
STEP
Openthe cartonin the flat
position, bottom facing
up to avoid damage.
STEP
Remove folded bed base from the box and
carefully unfold the base. Set it on its side
with the base half-way open.
Take caution to avoid pinning fingers or
any underside wires along the hinge.
STEP
Open the accessories box and ensure all accessories are included
(see pages 6-7).
With two (2) to four (4) people, lift
the bed by the outer frame and
turn it over so the mattress side
is facing up. Take caution not to
lift the bed by any moving parts,
the retainer bar, or to use the legs
as pivot points causing angled
pressure as this may cause
damage. Avoid dragging the base
across the floor.
STEP
STEP
STEP
5
1
6
Connect the remote cord into the
receptacle cord on the underside of
the base.
2
7
To complete assembly, plug the
power cord into the wall outlet and
use remote to test functionality.
3
To install the six (6) legs, thread the bolt of
the leg into the frame and tighten by hand.
4
Uncoil the input power cord (connected
to the control box on the underside of the
base) and plug it into the power supply
box.
-7-