Enterasys Matrix 7G4202-72 - Connecting to a VT Series Terminal; Connecting a VT Series Terminal

Connecting to COM Port for Local Management
3-14 Installation
Connecting to a VT Series Terminal
ToconnectaVTSeriesterminaltoanEnterasys NetworksDFE‐PlatinummoduleCOMport
(Figure 3‐10),useaUTPstraight‐throughcablewithRJ45connectorsandanRJ45‐to‐DB25female
adapter,andproceedasfollows:
1. ConnecttheRJ45connectoratoneendoftheUTPstraight‐throughcableto
theCOMporton
theEnterasys Networksmodule.
2. PlugtheRJ45connectorattheotherendoftheUTPstraight‐throughcableintotheRJ45‐to‐
DB25femaleadapter.
3. ConnecttheRJ45‐to‐DB25adaptertotheportlabeledCOMMontheVTterminal.
4. TurnontheterminalandaccesstheSetupDirectory.
Setthefollowingparametersonyour
terminal:
Whentheseparametersareset,theLocalManagementpasswordscreenwilldisplay.Refertothe
EnterasysMatrixDFE‐PlatinumSeriesConfigurationGuideforfurtherinformation.
Figure 3-10 Connecting a VT Series Terminal
Parameter Setting
Mode 7 Bit Control
Transmit Transmit=9600
Bits Parity 8 Bits, No Parity
Stop Bit 1 Stop Bit
1 UTP straight-through cable with RJ45 connectors 3 RJ45-to-DB25 VT adapter
2 RJ45 COM port 4 VT series terminal
COM
OFFLINE/
RESET
GROUP 3
GROUP 1 GROUP 2
CPU
MGMT
1X
6X
7G4202-72
Gb ENET
ÀÂÃ
Á