Enterasys Matrix 7G4202-72 - Removing the Existing DIMM from 7 G4282-49; Installing the DIMM on 7 G4282-49

Memory Locations and Replacement Procedures
DFE-Platinum Series Hardware Installation Guide B-5
Figure B-5 Removing the Existing DIMM from 7G4282-49
3. RotatetheDRAMSIMMupwards,thenremoveitfromtheconnectorfingers.
Installing the DIMM on 7G4282-49
ToinstallaDIMM,refertoFigure B‐6andproceedasfollows:
1. InserttheDIMMdownbetweentheconnectorfingers.
2. PivottheDIMMdownwardsothetabsontheconnectorarmsalignwiththetwoDIMM
alignmentnotches.Withthetwoconnectorarmsspreadoutward,pushtheDIMMdown
betweentheconnector
arms.ThenreleasethetwoconnectorarmstolocktheDIMMinto
place.
Figure B-6 Installing the DIMM on 7G4282-49
1 Connector arms 2 DIMM 3 Connector fingers
À
À
Á
Â
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive electronic
equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de
seguridad para evitar descargas de electricidad estática.
1 DIMM 3 Connector arms
2 Connector fingers 4 Alignment notches (2)
À
Á
Â
Ã
Ã
Â