Enttec MK2 - Changing Fuses

CV Driver MK2 Manual
50394
www.enttec.com
4
ID: 82325
o [DMX] Strikes upon receiving DMX
o [ON] Strikes Auto at Power Up
• DMX Personality
o 8 Bit 6-Channel Mode
o 9-Channel Extended Mode
o 16 Bit 12-Channel Mode
• DMX Start Address
• PWM Adjustment
• Identify Device
• Factory Defaults
Channel Distribution (DMX
Personalities)
The CV Driver handles each DMX channel as an RDM sub-
device, so you can assign independent addresses to each
channel which do not have to be consecutive. It is even
possible defining several channels to the same DMX ad-
dress.
Changing Fuses
The ALEPH CV DRIVER has 6 Amps, UL glass fuses for protect-
ing the outputs and can be changed by removing the metal
lid following these steps:
1- Un-power the unit. There are mains voltages inside, so
the unit must be never operated without the lid.
Strobe Rate
Value
Output Observed
000-010 →
Full Output depending on current
CH1- CH6 and Master Dimmer
channel.
011-252 →
Varies strobe frequency where 011
is the lowest and 252 the highest
(keeps the colour and master dim-
mer values from the other chan-
nels)
253-255 →
Full Output depending on current
CH1- CH6 and Master Dimmer
channels
Master Dimmer
Value
Output Observed
000 →
All outputs will be OFF (dimmed to
0%)
255 →
Full Output (100%) depending on
current CH1-CH6 and Strobe fre-
quency channels.
000-255 →
Dims all channels merging them
with the current CH1-CH6 and
Strobe rate channels. 000 is 0%
and 255 is 100% intensity.
Strobe Duration
Value
Output Observed
000 →
Shortest time that the LED stays
on while strobing
255 →
Longest time that the LED stays on
while strobing
Fuses Specifications
Size
5 x 20 mm
Current Rating
6 Amps
Voltage Rating
125V
Response time
Fast