3 4
3 Installation
3.1 Preparation
2.3 Technical Parameters
Model
Features
Communication Method
Monitor mode
Ethernet Connection
Wireless Communication
Applicable Voltage
Storage (Optional)
Power Control (Optional)
RS485 Port
AC Supply
Power Consumption
Dimensions (W*H*D)
Weight
Cooling
Ambient Temperature Range
Ingress Protection (IP)
Compliance
Warranty
108~264VAC, 47.5~62.0Hz
3 W
PLCC (Power Line Carrier Communication)
Real-time data monitored and remote control on app
TCP/IP
WIFI (802.11g/n)
Single Phase / Three-Phase
USB Local Storage
Automatic Control of Power Output
Virtual communication port, used for communication
and control between RS485 equipment and EVB300.
172mm*100mm*45.5mm
750 g
Natural Convection- No Fans
-40℃~+65℃
IP40
CE
3 Years
Interface
Capacity
Number of Devices Connected
Mechanical Data
AC Supply/Consumption
EVB300
Up to 60 Units of PV Modules in total
3.2 System Diagram
(1) Ethernet Mode
3.3 Installation Steps
Note: When mounting the EVB300 to a wall, make sure to select a cool, dry indoor
location.
Step1. Screw on the antenna.
Step2. Drill two holes on the wall surface (10cm apart), then insert 2 mounting screws.
(2) Wireless (Wi-Fi) Mode
Make sure you have the following components ready before beginning to
install the EVB300:
An AC electrical outlet (connected to microinverter).
A steady Internet connection (CAT5 Ethernet, or a wireless router).
A computer/cellphone.
To Next Page
Loading...
Need help?
General
