Envertech EVB300 - Add MI; Restart EVB; Upgrade; Password (Distributor)

13 14
(2) Restart EVB
Select Restart EVB and click Confirm, your device will restart in 3 minutes.
(4) Password (Distributor)
A. Password is required for first login,
default password: 123456.
B. Then input the origin password and
new password.
(5) Parameter Setting (Distributor)
A. MI Safety Param
Introduction:
Each micronvert appearance has an initial safety regulation, which is not applicable
to all countries, so the safety regulations are set to meet the standards of each
country.
Operation Steps:
Step1. Select Safety Param Selection
(3) Upgrade
Introduction: When a new version is released, the firmware can be upgrade remotely.
Operation Steps：
A. Select Upgrade.
B. Click “+” button on the up right
corner, then click download.
C. After the file downloaded, click
upgrade button.
Click “+” to add a new microinverter under the EnverBridge. The SN of the microin-
verter can be typed into the input box, or you can click the barcode icon and scan the
barcode on the microinverter. Click “Confirm” to finish adding the MI. This added
MI will be in the microinverter list then.
Step2. here are many countries you
can choose and a default SafetyParam
for all countries in the end.