Enviro GAS 828 BV. FS. - User Manual

20 pages

Save Page as PDF

To Next Page

SHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY

THIS MANUAL IS PRINTED ON RECYCLED PAPER

828

By SHERWOOD INDUSTRIES LTD.

B Vent

OWNERS MANUAL

Installation And Operating Instructions For Models:

828 BV. FS. (Freestanding)

828 BV. INS. (Insert)

PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.

WHAT TO DO IF YOU SMELL GAS

• Open windows/Extinguish any open flame

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any

phone in your building.

• Immediately call your gas supplier from a

neighbor's phone. Follow the gas supplier's

instructions.

• If you cannot reach your gas supplier, call the fire

department.

WARNING

If the information in this

manual is not followed exactly,

a fire or explosion may result

causing property damage,

personal injury or loss of life.

Installation and service must

be performed by a qualified

installer, service agency or the

gas supplier.

FOR YOUR SAFETY

Do not store or use gasoline or other Flammable vapors and liquids

in the vicinity of this or any other appliance.

Questions and Answers

B
bridgetschmittAug 8, 2025
Why won't the pilot light stay lit on my Enviro Indoor Fireplace?
- B
  bradleygravesAug 8, 2025
  There could be a few reasons why the pilot light won't stay lit on your Enviro Indoor Fireplace. One possibility is a problem with the thermocouple circuit. Ensure the thermocouple is properly connected to the rear of the valve; tighten it lightly if it's loose. Also, check that the pilot flame fully impinges around the thermocouple. If the pilot flame is too small, inspect the gas pressure, adjust the pilot rate screw, and check the pilot head for any blockages. You can check the thermocouple voltage at the rear of the valve; it should be greater than 5 mV. If it's low, consider replacing the thermocouple. Another cause might be air in the gas line, which can cause the pilot flame to die while the knob is depressed. In this case, bleed the line and check the gas line pressure.
M
Matthew LewisAug 25, 2025
What to do if the spark won't arc to the pilot on my Enviro GAS 828 BV. FS.?
- E
  Elizabeth EllisAug 25, 2025
  If the spark won't arc to the pilot on your Enviro Indoor Fireplace, it could be due to a few reasons. First, check the connections to the ignitor. If the connections are good but there is still no spark, the ignitor may be defective and need replacing. Another possibility is a broken spark electrode; check for broken ceramic insulation and replace the electrode if broken. Finally, the spark electrode may be misaligned. If the spark is not arcing from the electrode to the pilot, adjust it by loosening the screws on the pilot base, moving it away from the burner, and then re-tightening the screws.

Summary

Safety and Emergency Procedures

Gas Leak Procedures

Step-by-step instructions for handling gas leaks safely.

General Safety Warnings

Crucial warnings regarding fire, explosion, and injury risks.

Safety Precautions

General Safety Guidelines

Guidelines for safe operation and maintenance by qualified personnel.

Additional Safety Precautions

Dimensions and Clearances

Fireplace Insert Clearances

Freestanding Clearances

Stove Location Guidelines

Assembly and Installation

Preparation for Installation

Steps before assembling the appliance, including damage checks.

Fireplace Insert Assembly

Detailed steps for installing the fireplace insert model.

Freestanding Appliance Assembly

Detailed steps for assembling the freestanding appliance model.

Gas Line Connection and Testing

Orifice Sizes and Pressures

Venting

Automatic Flue Gas Spill Switch

Fireplace Insert Venting

Freestanding Model Venting

Air Shutter Adjustment

Operating Instructions

Lighting Instructions

Step-by-step guide for lighting the pilot and main burners.

Gas Valve Operation

Turning Off the Appliance

Routine Maintenance

Troubleshooting

Warranty Information

Enviro GAS 828 BV. FS. Specifications

General

Fuel Type	Natural Gas or Propane
Ignition Type	Electronic Ignition
Venting	Direct Vent
Finish	Black
Log Set Material	Ceramic Fiber
Burner Material	Stainless Steel
Warranty	Limited Lifetime Warranty