6. ELECTRICAL REQUIREMENTS
The ENVIROGAS 828 Series will operate without an external electrical power supply. This model has a Millivolt gas control
which uses the pilot flame to generate enough electricity to operate the main burners.
CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and
dangerous operation. Verify proper operation after servicing.
FAN INSTALLATION
OPTIONAL FAN
Efficiency and heat output of the unit increases with the operation of the fan.
• This appliance is equipped with a three-prong (grounding) plug for your protection against shock hazard, and should be plugged
directly into a properly grounded three-prong outlet. DO NOT cut or remove the grounding prong from this plug.
The appliance, when installed with optional blower , must be electrically connected and grounded in accordance with local codes or in
the absence of local codes, with the current CSA C22.1 CANADIAN ELECTRICAL CODE Part 1, SAFETY STANDARDS FOR
ELECTRICAL INSTALLATIONS, OR THE NATIONAL ELECTRICAL CODE ANSI / NFPA 70 in the USA.
8
To Next Page
Loading...
Need help?
General
