To Next Page

To Previous Page

CLASSIC-100 AXIAL EXTRACTOR FANS

Suitable for bathroom applications

INSTALLATION

IMPORTANT: before installing and wiring the unit, ensure that the mains supply is

disconnected.

CLASSIC-100 sh ould only be used in conju nction with fixed wiring.

Fig.1 1 – Grille

2 – Cable entry point

3 – Connection cover

4 – Fixing screw

5 – Connection termin als

6 – Outlet

7 – Slot

The CLASSIC-100 is suitable for wall, ceiling or window (using the CLASSIC-100 window

kit) i nstallations.

Panel M odel

Drill a 105mm-diameter hole in chosen position in the panel surface.

Loosen the screw (4), which holds the grille in place (1) and remove grille.

Mark the fixing holes in the back of the fan plate. This fan must be installed by a

competent person. Complete electrical wiring of fan as outlined in the Wiring

Instructions o verleaf. Then refit the grille and tighten the screw (4).

Bind the adhesive tape supplied around the outlet (6).

Wall Model

Drill a 115mm d iameter hole in chosen position through the wall. Slope the wall

slee ve downwards to prevent rainwater running through the duct into the unit. The

end with the larger diameter should be on the room side.

Loosen the screw (4), which holds the grille in place (1) and remove grille.

Mark the 4 screw hole positions. Drill, plug and screw into position. Repeat this

process for the external grille sub-

frame. Fix the exterior grille in position, whilst

ensu ring that the louvres are positioned downwards.

Check t hat the wall tube is not distorted and that the impeller turns freely.

This fan must be installed by a competent person. Complete electrical wiring of fan as

outlined i n the Wiring Instructions below. Then refit the grille and tighten the screw (2).

Bind the adhesive tape supplied around the outlet (6).

•

Envirovent CLASSIC-100 User Manual

Questions and Answers: