EN-7100e
8
31MY02
EN-7100e
Before You Operate the Monitor
Preparing to Install An Optional Wall Mounting Arm (Not supplied)
This monitor can be attached to a wall mounting
arm you purchase separately. Disconnect power
before this procedure. Follow these steps:
1. Pull the screw covers off the back of the monitor.
2. Support the base and remove the screws.
3. Unhook the cable into the monitor. Remove
the base.
4. Remove the back cover from the panel.
5. Follow the manufacturer’s instructions to
assemble the wall mounting arm.
See next page for further installation instructions.
To Next Page
Loading...
Need help?
General
