ENVO D35 - Page 32

ENVO D35 | ST EBIKE MANUAL | VERSION 1.0 32
To enter the Advance settings, you need to input the default password “1919”. The speed limit on
your ebike is set between 35-38 km/h as the default value. Although the maximum permissible
speed for ebikes is 32km/h in Canada, this value is set slightly higher than the limit because the
loaded speed will always be lower than this maximum value. The user’s responsibility is to ensure
they never exceed 32km/h speed when riding to stay within the legal limit. The current limit range
goes from 6A to 50A and depends on the battery and motor you are using. The poles in motor
settings refer to magnetic poles inside the motor and start after poles refer to poles speed sensor
needs to detect before controller turns on the motor. Clockwise start refers to speed sensor turn
direction. The throttle settings decide the speed at which the bike will run when in walking mode.
You can limit it to 6km/h or set a speed depending on the assist level or set a maximum speed, as
seen in the next picture.
Selecting Y will throttle speed according to the assist level. The other option is N represents
maximum speed. The start mode is power, eco, and standard, and each uses a different set of
power. The assist level can be dened using programmed options 3,5,8, or users can input their
value.
• You do not need to change any of the default settings. Please do not do so if not necessary.
Wrong settings may stop the system from functioning, cause loss of some functionalities, or
damage components of the ebike
• There is a small battery in the 750c LCD display that gets charged during use. If the new bike is
not used regularly, the battery will not gain sucient charge to stay powered for long periods. If
needed, leave the display on for 72 hours by turning the auto off setting from the default of 5m
to “OFF,” this should charge the cell suciently
• Make sure PAS (pedal assist) is at level 0
Figure 5E