What to do if Epever Inverter shows output overload?
If the Epever Inverter indicates an output overload, reduce the number of AC loads connected to the inverter. Then, restart the device to restore the load output.
What to do if Epever UPower-HI Inverter shows output short circuit?
If the Epever Inverter displays an output short circuit, carefully inspect the load connections and correct any faults. Following this, restart the device to restore the load output.
How to fix battery over voltage on Epever UPower-HI Inverter?
To address a battery over voltage issue on the Epever Inverter, first check if the battery voltage is excessively high. If it is, disconnect the PV modules.
What to do if Epever UPower-HI battery over discharges?
If the Epever Inverter's battery over discharges, wait for the battery voltage to return to or exceed the LVR (low voltage reconnect) point. Alternatively, change the power supply method.
What happens if there's an output short circuit in my Epever Battery Charger?
If there's an output short circuit with the Epever Battery Charger, the inverter will fast flash.
What happens if my Epever Battery Charger battery over voltage?
If the battery voltage is too high in your Epever Battery Charger, it will flash.
What does it mean if the output voltage is abnormal on my Epever Battery Charger?
If the output voltage of your Epever Battery Charger is abnormal, the inverter will fast flash.
What to do if my Epever Inverter has an output overload?
If the Epever Inverter indicates an output overload, reduce the number of AC loads connected to it. Then, restart the device to restore the load output.
What to do if my Epever Inverter shows an output short circuit?
If the Epever Inverter experiences an output short circuit, check the load connections carefully and clear any faults. Then, restart the device to restore the load output.
What to do if my Epever UPower-HI Inverter shows battery over voltage?
If the Epever Inverter indicates a battery over voltage, check if the battery voltage is too high and disconnect the PV modules.
General| Output Waveform | Pure sine wave |
|---|---|
| Input Voltage | 12V/24V/48V DC |
| Output Frequency | 50Hz/60Hz |
| Rated Power | 2000W / 3000W |
| Peak Power | 4000W / 6000W |
| Efficiency | 90% (Typical) |
| THD | <3% |
| Cooling Method | Fan Cooling |
| Protection Features | Overload protection, Short circuit protection, Over temperature protection |
| Communication | RS485 |
| Operating Temperature | -20°C to +50°C |
| Storage Temperature | -30°C to +70°C |
| Dimensions | Varies by model |
| Weight | Varies by model |
To Next Page