EPH Controls COMBIPACK4 - Identifying if a receiver is a Hub Receiver; Pairing the RF1 A-OT receivers together

44
RFRP-OT OpenTherm® Instructions
Controlling an OpenTherm® Boiler with
multiple CombiPack4-OT (Continued)
Identifying if a receiver is a Hub Receiver
Pairing the RF1A-OT receivers together
1. Press the
Connect
button.
2. The Hub receiver will ash Green and Red.
3. The Normal receiver will just ash Red.
4. To exit to main interface press the
button.
Once all units have been paired, allow time for the receivers to begin
to communicate and receive OpenTherm® information from the boiler.
This may take approximately 2 – 5 minutes.
1. Press the
Connect
button on the Hub receiver. Red and Green lights will
begin to ash.
2. Press the
Connect
button on the next receiver to be paired. The Red light
will ash 3 times and then stop.
3. Repeat this process to pair more, up to a maximum of 6 receivers.