45
RFRP-OT OpenTherm® Instructions
Disconnecting the RF1A-OT receiver from Thermostats & other Receiver
1. Press
Connect
on the Receiver – the red light will ash (red and green
light if using a hub receiver)
2. Press and hold
Connect
for about 10sec and the receiver will then stop
ashing.
3. The RF connection is now cleared.
You will see the red light ash on the Hub receiver and see a
corresponding ash on the other receivers paired to the Hub Receiver
when they are sharing information.
You may need to pair the receivers to the thermostats again.
If so, please refer to page 51.
You can tell if your thermostat is receiving OpenTherm® information
from the boiler by entering the installer menu of the thermostat (Hold
Prog and OK buttons for 10 Sec) and go to P07 - Info.
If the installer menu is only showing P01 – P05, the thermostat and/or
receiver has not been successfully paired.
To Next Page
Loading...
