6
1. Reset your router by switching it
on and off.
2. Ensure that your thermostat(s)
are paired to your receiver(s).
This can be tested by turning the
thermostat on or off and ensuring
the receiver is switching on and
off accordingly. If a thermostat is
not paired to the receiver please
follow the instructions in Section
17 of the thermostat Operating
Instructions.
3. Ensure that the receiver you’re
connecting to the boiler is set up
as a hub receiver. For instructions
on your to do this, please refer
to Section 2 of the thermostat
OpenTherm® Instructions.
4. Press the ‘Connect’ button on the
receiver. The Red and Green LEDs
will begin to ash.
Note: If you are connecting multiple receivers to a gateway, please ensure that all
branch receivers are connected to the hub receiver. There can only be 1 hub receiver
in a system. Allow 5 minutes for all receivers to synchronise with the hub receiver
before connecting the gateway to the EMBER App.
* Please note: If you are installing a CombiPack4, the RFRP-OT thermostat and the
RF1A-OT receiver will have a pre-established RF connection so it is not necessary to
carry out Step 2 in the RF connection process below.
** Please note: If you are installing a CP4i, the thermostat, receiver and gateway will
have pre-established RF connections so there is no need to carry out Step 3 in the RF
connection process below.
Pairing your receiver to
your gateway
Complete this step before pairing your receiver to your gateway
5. On the Gateway, press and
hold the ‘Function’ button for 3
seconds.
6. The White LED on the gateway
will begin to ash at 1 second
intervals.
7. When the White LED stop ashing
and is solid On, the gateway
has been connected to the hub
receiver.
To Next Page
Loading...
