44
NORMAL OCCURRENCES
The following things are normal and not any reason for concern.
ISSUE NORMAL FUNCTIONALITY
WHIR
The indoor fan runs continuously when the HPAC 2.0 is operating in the
cooling mode.
3-MINUTE DELAY
You may notice a few minutes’ delay in starting if you try to restart the
HPAC 2.0 too soon after turning it off, or if you adjust the thermostat right
after the compressor has shut off. This is due to a built-in restart protector
for the compressor that causes a three-minute delay.
SILENCE
During the defrost cycle, both the indoor and outdoor fans stop and the
compressor will operate in the cooling mode to remove frost from the
outdoor coil. After defrosting, the HPAC 2.0 will restart in electric heat to
quickly warm the room to the desired comfort level.
HPAC 2.0 STAYS ON AFTER
TURNING IT OFF
To protect the compressor and prevent short cycling, the HPAC 2.0 is
designed to run for a minimum of three minutes after the compressor starts
at any thermostat setting.
To Next Page
Loading...
