Ephoca HPAC 2.0 User Manual

49
E6 E7 CP OF (COOL) OF (HEAT)
Faulty external
fan motor.
Lack of commu-
nication with the
d
isplay.
Open CP con-
tact.
In cooling/
dehumidification:
Maximum level float.
In Heating: Maximum
level float intervention
motor.
None of the
modes can be
activated.
Display can’t
connect to the
HPAC 2.0.
The HPAC 2.0
only works if
the contact is
closed.
During cooling and
dehumidification, a
sensor keeps the
water distribution
system active with the
fan to disperse excess
water.
During heating,
condensation should
drain freely through
the specific pipe, and
the pipe is blocked.
Disconnect the
power, wait five
minutes, recon
-
nect the power.
D
isconnect the
power, wait five
minutes, recon-
nect the power.
Check that the
sensors are
connected.
Disconnect the power,
wait five minutes, re-
connect the power.
Disconnect the power,
check that the
condensation pipe is
not bent or obstructed,
preventing the water
from flowing out.
Nothing. Nothing Nothing Nothing Nothing
No No No No No
The HPAC 2.0 The HPAC 2.0 The HPAC 2.0 The HPAC 2.0 The HPAC 2.0

Ephoca HPAC 2.0 Specifications

General

Brand	Ephoca
Model	HPAC 2.0
Category	Heat Pump
Language	English