Safety and operating instructions
© Construction Tools GmbH | 3390 5149 01 | 2020-09-22
Original Instructions
9
2.3.1 Generator system
The generator system described in this manual is a mod-
ular energy-generating system for Hydro Magnets. The
generator system is intended for use as fixed mounted
power generator.
• The generator system is to be used exclusively for
the magnet plate of Hydro Magnets of the HM se-
ries.
• Only use the generator system in accordance with
the voltage and power specifications on the name-
plate.
• Drive the generator system with the specified nomi-
nal speed.
• Use the generator system only for the purposes
specified in these Safety and Operating instructions.
Any other use is improper and not permitted.
Installation and commissioning of the Hydro Magnet may
only be carried out by qualified personnel who are autho-
rized to commission, ground and label devices, systems
and circuits in accordance with the standards of safety
technology.
2.4 Use other than intended
Incorrect, inappropriate use and lack of maintenance can
cause dangerous situations. Injury or damage may re-
sult.
Never use the Hydro Magnet:
• for transport or lifting of persons.
• if there are people in the work area.
• when people stand or work under suspended loads.
Both persons and raised objects can fall/be dropped.
Both can lead to serious injury or death.
• Never start demagnetization before the load is on
the ground or hovering just above the discharge
point.
A falling object can result in serious injury or death.
• Prevent the use of the Hydro Magnet by people who
are:
- unqualified or
- in poor health.
Uncontrolled, improper use can result in serious injury or
death.
• Never use the Hydro Magnet in an environment con-
taining acid gases or abrasive powder.
Cables and connectors may be damaged and cause in-
sulation damage.
Never use the Hydro Magnet:
• under water.
• in towing or pushing operations.
The Hydro Magnet is not designed for this operation.
Unallowed Loads:
• Loads exceeding the specified load capacity.
• Loads that are almost at the load limit capacity but
do not cover the entire magnetic surface.
• Loads that are dirty and could therefore have a
larger air gap.
• Loads with a temperatur considerably higher than
the ambient temperature.
To Next Page
Loading...
Need help?
General
