To Next Page
A
Alejandro BirdAug 9, 2025
What to do if Epiroc COP M6 Construction Equipment impact mechanism does not operate?
- JJustin DavisAug 9, 2025
If the impact mechanism on your Epiroc Construction Equipment isn't working, start by checking the air pressure and ensuring all air passages to the hammer are open. If that doesn't solve it, the issue might be poor lubrication. Try blowing operating air through the rotation spindle onto a dry plank; the plank should become oily after a few moments. Inspect the lubricator, topping it up with oil or increasing the oil dosage if needed. Other potential causes include excessive wear between the piston and casing or control tube, a hammer clogged with dirt, worn buffer rings in the cover, or a damaged O-ring in the bit bushing. In such cases, disassemble the hammer to inspect for wear, wash all components, or replace the buffer rings or O-ring as necessary.
General
