Installation Preparation
Remote control holder installation 1
1. Drill a 6 mm diameter hole in the wall to a depth of about 35 mm.
3. Install an anchor into the hole, stick the holder to the wall and secure with screws and then
stick the patch with tape.
3. Stick the holder to the wall vertically and then stick the patch with tape.
1. Insert batteries into the remote control.
2. Put the remote control to the holder.
Remote control holder installation 2
Battery installation:
Notice:
1. Please ensure the remote control is within reach when a person on the seat.
2. Do not install and use the product in damp places such as a shower room.
3. Do not place the product in a place where it is easily exposed to water.
Double-side tape
patch
Double-side tape
patch
Installation area
Battery cover
01
Remote control installation
To Next Page
Loading...
