E+E Elektronik EE33 - Replacement Parts; Accessories

34
EE33 Humidity / Temperature Sensor for High Humidity and Chemical Applications
For the network configuration, the following plug connectors
are also necessary:
- Y splitter: Siemens 6ES7 194-1KA01-0XA0
- Plug: Lumberg RSC 5/7
Lumberg
RSC 5/7
Y-splitter *
Lumberg
RKC 5/7
RS485
network
* Siemens 6ES7 194-1KA01-0XA0
power supply+
analogue output
RS232/485 converter:
To adapt the RS232 interface on the PC to the RS485 network protocol, a signal converter is required
(see schematic “network configuration” above).
12 ReplacementParts / Accessories
Please also refer to the “Accessories“ data sheet.
Filter
- Sintered stainless steel HA010103
- PTFE HA010105
- Metal grid HA010106
Display + enclosure cover in metal D05M
E+E Product Configuration Software EE-PCS
(free download: www.epluse.com/configurator)
Configuration cable (for EE-PCS) HA010304
Interface cable for plug option E5 HA010311
Mounting flange 12 mm (1/2") HA010201
Mounting flange 6 mm (1/4") HA010207
1/2" ISO screw connection 12 mm (1/2") HA011102
1/2" ISO screw connection 6 mm (1/4") HA011104
1/2" NPT screw connection 12 mm (1/2") HA011103
1/2" NPT screw connection 6 mm (1/4") HA011105
M16x1.5  1/2" NPT adapter for conduit fittings HA011101
Drip water protection HA010503
Humidity calibration kit HA011xxx
(free download: www.epluse.com)
RS485 networking kit (HW + SW) HA010605
Datalogging and analysis software HA010602
Adapter M16x1.5 to NPT 1/2 HA011101
Radiation shield for 12 mm RH probe HA010502
Radiation shield for 6 mm T probe HA010506
Radiation shield LAM630 for EE33 Type T17 with control unit HA010508
Mounting set for mast with Ø34 - 54 mm (1.3 - 2.1") HA010213
HUMOR 20 adapter for EE33 Type T17 HA020401