Epomaker GK68 Extended Manual 10/07/20
Add Onboard Lighting Effects
We’re going to be adjusting the on-board lighting effects. You can access these effects by using
FN + ] Until you reach the effect you created.
1. Launch the software with the keyboard connected in wired mode. The keyboard must
use the cable given, or a USB-C to USB-A cable. The USB-A connection gives the ability
for the driver to interface and detect the software. You can use a dongle to connect your
keyboard to a USB-C connection on a Mac.
1. When the software is installed, please launch it and press the “Standard Layer”.
Version 1.2 31
To Next Page
Loading...
