Epomaker GK96S - Setting Up Keyboard;Bluetooth; Windows 10 Bluetooth

Epomaker GK96S/SK96S Extended Manual Version 1.2
The default on this layer is the following:  Spectral Cycle, GK96XS-1, Spectral Cycle,
Windmill and Rainbow Waves
Driver Layer (FN + 5): Q light will light up when this mode is selected. Driver mode layer
only works when the keyboard is connected wired, and allows you to modify the backlight
colours in real-time. You can assign larger macros while connected through a cable vs storing it
on-board.
Layer 1: Onboard memory layer, The “5” key will light up when this mode is selected.
This layer will work without having to be connected wired, but you’re limited to what lighting you
saved onboard (similar to the “standard layer”).
Layer 2: Onboard memory layer, The “6” key will light up when this mode is selected.
MacOS layer. This layer is the same as Layer 1 and 3, but by default has the keys rebinded to
match a MacOS keyboard and the Backspace key will be binded to delete. This can be changed
in the driver.
Layer 3: Onboard memory layer, The “7” key will light up when this mode is selected.
This layer will work without having to be connected wired, but you’re limited to what lighting you
saved onboard (similar to the “standard layer”).
Setting Up Keyboard/Bluetooth
Windows 10 Bluetooth
1. First, charge the keyboard via a USB port on your computer until it has decent charge.
2. Power on the keyboard using FN + Space. This will put your Epomaker GK96S/SK96S
in Bluetooth mode.
3. Long Press Either FN + 1, FN + 2, or FN + 3 for about three seconds. The key will start
to flash red and green. This means that the keyboard is in pairing mode.
9