BIOS
Page 4-10
T (RP)
This item refers to the number of cycles required to return data to its original
location to close the bank or the number of cycles required to page memory before
the next bank activate command can be issued.
Options: 1 ~ 7.
CAS Latency
Enables you to select the CAS latency time. The value is set at the factory depending
on the DRAM installed. Do not change the values in this field unless you change
specifications of the installed DRAM.
Options: 2.0, 2.5, 3.0.
FSB Spread Spectrum
This item can significantly reduce the EMI (ElectroMagnetic Interference) generated
by the CPU.
Options: Disabled, 0.50%, 1.00%.
AGP Spread Spectrum
This item can significantly reduce the EMI (ElectroMagnetic Interference) generated
by the AGP.
Options: Disabled, 0.50%, 1.00%.
AGP Aperture Size (MB)
This item defines the size of the aperture if you use an AGP graphics adapter. It
refers to a section of the PCI memory address range used for graphics memory.
Options: 32, 64, 128, 256, 512 MB.
AGP Frequency
This item allows you to select the AGP frequency.
Options: Auto, 90MHz, 93MHz, 95MHz, 97MHz, 100MHz, 50MHz ~87MHz in 1MHz
increments.
AGP 8X Support
Enables AGP 8X supports.
Options: Disabled, Enabled.
AGP Fast Write Capability
This item allows you to use Fast Write protocol for AGP card.
Options: Disabled, Enabled.
To Next Page
Loading...
