22
The centrifuge 5702 is a floor centrifuge for use by trained professionals in routine, training and
research laboratory work in the biosciences, industry, hospitals, and the chemistry field. Its
varying rectangular buckets, round buckets and adapters make it specially well suited to
centrifugation of blood sampling systems, Falcons
®
and centrifuge tubes. The fixed-angle rotor
F-35-30-17 has a capacity of 30 x 15 ml DIN centrifuge tubes.
Before using the centrifuge 5702 for the first time, please read the operating manual.
You will see this symbol on your centrifuge and at a number of points throughout this
manual. The texts it highlights are relevant to safety. Use the centrifuge only after
having read the safety notices.
1 centrifuge 5702 without rotor
1 power cable
1 operating manual
1 rotor key
1 set of fuses
1 pivot grease
– Place the centrifuge on a solid, flat, non-resonant lab bench.
– The surrounding area must be well ventilated and protected against direct sunlight.
– During centrifugation, according to the recommendations set out in EN 61010-2-020
a safety clearance of 30 cm should be maintained around the centrifuge within which
there are no objects which may be destroyed and so cause further damage.
– Please remove the transport safety device and keep it for possible use if the device is
subsequently moved again.
– Make sure the line voltage and frequency match the specifications on the device
identification plate.
– Now connect the centrifuge to the supply system and switch it on at the main power
switch. The Standby button lights up red. Press the button and the centrifuge is
ready for operation. The Standby button lights up green and the display is active.
– Before starting, check that the rotor is firmly seated.
1.1 Delivery package
1.2 Installing the device
1 Introduction
Introduction
1
To Next Page
Loading...
