Contents 0-1
Centrifuge 5804/5804 R and 5810/5810 R
Contents
1 Safety precautions
Warning and hazard symbols in this Service Manual ..................................................... 1-1
Risk to persons ................................................................................................................... 1-2
Risk of damage to device................................................................................................... 1- 2
Risks through incorrect handling of centrifuge .............................................................. 1- 3
Risks through incorrect handling of rotors...................................................................... 1- 3
Risks through extreme stress on test tubes.................................................................... 1- 4
Risks from products, chemicals and extreme ambient conditions ............................... 1- 4
Emergency cut-off.............................................................................................................. 1- 5
2 PACT Information sheets
3 Error lists / Troubleshooting
Error list 58XX ..................................................................................................................... 3-1
Errors from the service programs.................................................................................... 3-10
Warnings / Error displays ................................................................................................ 3-12
Problems with defective frequency converter,
motor, brake resistors, overload, error 6......................................................................... 3-17
Customer service programs .............................................................................................. 3-18
Service programs 58XX...................................................................................................... 3-21
General description ......................................................................................................... 3-21
Program overview............................................................................................................ 3-22
Description of the individual service programs ............................................................... 3-23
Setting of the serial interface........................................................................................... 3-23
Voltage version (set after replacing PCB Control) ......................................................... 3-23
Check of the display and keypad .................................................................................... 3-23
Lid function test...............................................................................................................3-24
Initializing......................................................................................................................... 3-24
Switching the aggregates / temperature sensor test (only for refrigerated devices) ..... 3-25
Cycle program ................................................................................................................. 3-26
Rotor recognition test / rotor pulses ............................................................................... 3-27
Frequency converter test (FC) ......................................................................................... 3-27
Imbalance calibration carried out by a service technician .............................................. 3-28
Overview of rotors required and weights: G1/G2/G3...................................................... 3-29
Overspeed cut-off test .................................................................................................... 3-30
Viewing the error table..................................................................................................... 3-31
Display for the number of starts / number of runs .......................................................... 3-31
Viewing the values stored in the EEPROM...................................................................... 3-33
Deleting the error table .................................................................................................... 3-34
Rotor table, Rotor relations ............................................................................................... 3-35
MSTM/MMWT/0408
To Next Page
Loading...
