Eppendorf Mastercycler nexus - Page 74

System management
Mastercycler
®
nexus
English (EN)
74
8.4.1 Cycler system functions
The System node contains the cycler system level with the following softkeys.
Status •Display the cycler operating status
•Display the temperatures of the thermoblock and the heated lid
•Display the remaining run time for the program
•Stop the program
Protocol Protocols of the last 20 program runs:
 Select the protocol via the arrow keys.
• Print softkey: print the protocol
• Export softkey: copy the protocol to a storage medium
• Show softkey: display the protocol
The following applies to devices with a thermoblock with 64+32 wells:
The Cycle functions comprise the Properties, Overview, Status 64 and Status 32 softkeys.
The Incubate and Protocols softkeys are located under the subnodes Block 64 or Block 32.
Info •Display the device name
•Display the date of the last verification
•Display the date of the last verification
•Display the programs run (since the last verification)
•Display the date of the last self-test
• Display the date of the next self-test
•Display the programs run (since the last self-test)
•Display the date of the last adjustment
Details about the next verification or self-test are only given if the settings have been
made under Service intervals ((see p. 70)).
Restart Entry for maximum duration of interruption of voltage supply (mm:ss) after which a
running program should be automatically restarted. The program is not restarted after
a longer interruption.
Sensors Display current sensor temperatures for the control loops of the thermoblock and the
heated lid.