Eppendorf Mastercycler nexus - Stopping and Starting Programs

Quick start
Mastercycler
®
nexus
English (EN)
89
9.6 Stopping and starting programs
1. Mark the program.
2. Insert the sample tubes.
3. Close the heated lid.
4. Start the program.
5. If several cyclers are connected:
highlight the cycler.
6. Confirm input.
7. The following options are available in
the status view:
•Stop the program: press the Stop
softkey.
•Abort the program: press the Abort
softkey.
•Resume the program: press the
Resume softkey.
start
enter