When the analysis is complete, the program displays a summary of
the status of the disk. This summary lists these counts:
l Flagged bad tracks
l
Tracks with read, verify errors
l Good tracks.
If no errors occur, you see this message:
No read, verify error was detected.
If errors are found, the program displays a table of the tracks that
gave errors, similar to the one displayed by the destructive analysis.
After the status reports you see this message:
Press ENTER to return to the menu.
Check the information displayed, then press
Enter.
--
D-10 Physically Formatting a Hard Disk
To Next Page
Loading...
