Epson 20 - Formatting Diskettes with One Diskette Drive (no Hard Disk)

4. When the diskette is formatted, you see a message similar to this:
Format complete
1213952 bytes total disk space
1213952 bytes available on disk
Format another (Y/N)?
At this point, you can either format another diskette by pressing
Y and Enter, or return to the MS-DOS command prompt by
pressing N and Enter.
Formatting Diskettes With One Diskette Drive (No
Hard Disk)
1. Insert the working copy of your MS-DOS Startup diskette in
drive A.
2. When you see the A> prompt, type the following and press
Enter:
FORMAT A:
You see this prompt:
Insert new diskette for drive A:
and strike ENTER when ready
3. Remove the MS-DOS Startup diskette from the diskette drive.
Insert the diskette you want to format into drive A and press
Enter.
4. When the diskette is formatted, you see a message similar to this:
Format complete
1213952 bytes total disk space
1213952 bytes available on disk
Format another (Y/N)?
At this point, you can either format another diskette by pressing
Y and Enter, or return to the MS-DOS command prompt by
pressing N and Enter.
Using MS-DOS with Your Equity 386 5-19