62 Maintaining Your Printer
5. Shake the new cartridge four or five times
before opening its package. (Don’t shake it
after it’s unpacked.)
6. Remove the new cartridge from its package.
7. Slide the new cartridge into its slot. The side
with the green circuit board goes in the back
of the slot.
8. Press the cartridge down until it clicks into
place.
9. If you need to replace any other ink
cartridges, repeat steps 4 through 8 before
continuing with step 10.
10. Close the cartridge cover, then close the
printer cover.
11. Press the H ink button. The printer begins
charging the ink delivery system.
The green P power light and red H ink
lights flash and the printer makes noise.
Charging takes about a minute. When it’s
finished, the green P power light stops
flashing and stays on, and the red H ink
lights go out.
Caution: Never turn off the printer while the green P power light is flashing,
unless the printer hasn’t moved or made noise for more than 5 minutes.
Cartridge
cover
Caution: Don’t touch the green circuit
board on the back of the cartridge; you may
inhibit normal operation and printing.
Close cartridge cover and
printer cover, then . . .
press H ink
button
To Next Page
Loading...
