2-2
Scanning Basics
Scanning Procedure
For reflective documents
You need to perform the following procedure to scan the
reflective documents on your scanner using a TWAIN-compliant
application. Details are described below.
1. Place a document on the scanner.
2. Start a TWAIN-compliant application.
3. In the application, open EPSON TWAIN 5 using a command
such as Acquire.
4. EPSON TWAIN automatically previews the images, and
recognizes the document source and type. Images are
automatically optimized and scanned.
5. Save the scanned images.
This following sections describe each of these steps in details.
For transparent materials
This scanner is suitable for scanning of slides and film. You need
to perform the following procedure to scan the transparent
materials using the integrated TPU. Details are described below.
1. Remove the reflective document mat from the integrated
TPU.
2. Load slides or film into the film holder and set it with the
integrated TPU.
3. Start a TWAIN-compliant application.
To Next Page
Loading...
