Epson 610

EPSON Perfection 610 Revision B
Assembly and Disassembly Disassembly Procedures 40
4.2.8 Panel Board Removal
1. Release the Carriage Lock. (See Section 4.2.1.)
2. Remove the Document Cover. (See Section 4.2.2.)
3. Remove the Upper Housing. (See Section 4.2.3.)
4. Remove the screw (gold, CBS, M3x4).
5. Disconnect the locking connector (pull and release) for the Panel
Board from the Power Supply Board, and then remove the Panel
Board.
Figure 4-30. Panel Board Removal
CHECK
POINT
In the following steps, manually move the carriage
back and forth slowly if necessary.
Connector
Panel Board
CBS Screw (M3x4)