Epson 610

EPSON Perfection 610 Revision B
Assembly and Disassembly Disassembly Procedures 42
6. Remove the two screws (gold, CBS, M3x4) securing the shield
plate, and then remove it toward the inside.
7. Disconnect the cable from the locking connector (push and release),
remove the five screws (gold, CBS, M3x4), and then remove the
Power Supply Board from the shield plate.
Figure 4-32. Power Supply Board Removal (1)
Figure 4-33. Power Supply Board Removal (2)
Figure 4-34. Power Supply Board
Shield Plate
CBS Screws (M3x4)
CBS Screws (M3x4)
Connector
CBS Screws (M3x4)