B-1
B
Follow the instructions in this appendix to install the printer
software on your computer.
If your system is on a Windows NT 4.0, Windows 95, or
Macintosh network, follow the steps in this appendix to
configure your printer software for network printing.
Installing Your Printer Software
Follow the steps in these sections to install your printer
software:
◗ For Windows 3.1 instructions, see the next section.
◗ For Windows 95 instructions, see page B-2
◗ For Windows NT 4.0 instructions, see page B-4
◗ For Macintosh instructions, see page B-5
Installing Printer Software for Windows 3.1
1. Make sure the printer is connected to your computer as
described on the Start Here card.
2. Turn on the printer and wait until the
Ppower light stops
flashing. Then turn on your computer.
Installing
Printer Software
and Configuring
on a Network
Note:
If you’re using a
stand-alone Macintosh or
a stand-alone PC running
Windows 95, follow the
quick instructions on your
CD-ROM folder to install
your printer software. If
you need more detailed
instructions, see the
steps in this appendix.
easapb.fm5 Page 1 Tuesday, March 24, 1998 1:17 PM
To Next Page
Loading...
