Specifications
D-10
Print position motion:
ESC d, ESC R, ESC D, HT, ESC B, VT, ESC J, ESC J (AGM*)
Font selection:
DC2, ESC P, ESC :, ESC E, ESC F, ESC I
Font enhancement:
DC4, SO, ESC SO, ESC W, ESC [ @, SI, ESC SI, ESC G, ESC H,
ESC T, ESC S, ESC -, ESC _
Spacing:
BS, SP, ESC [ \
Character handling:
ESC 6, ESC 7, ESC [ T, ESC ^, ESC \
Bit image:
ESC K, ESC L, ESC Y, ESC Z, ESC [ g, ESC * (AGM*)
* Alternate Graphics Mode
Character Tables
All character tables except Italic are the same as the PC437 table for
hex codes 00 through 7F. Additional characters are available for hex
codes 80 through FF. You can select the following character tables
through the control panel or software commands:
• PC 437 (U.S./Standard Europe)
• PC850 (Multilingual)
• PC860 (Portuguese)
• PC861 (Icelandic)
• PC863 (Canadian-French)
• PC865 (Nordic)
• Abicomp
• BRASCII
• Roman 8
• ISO Latin 1
• Italic (no characters available for hex code 15)
International
character sets
You can select a number of international character sets with the
control panel or the ESC R command. Other sets can only be selected
with the ESC R command. You can select additional characters with
the ESC ( ^ command.
easapd.fm5 Page 10 Tuesday, March 24, 1998 1:18 PM
To Next Page
Loading...
