Epson AcuLaser C4000 - Page 5

(5/22)
EPSON AcuLaser C4000 Quick Reference
Clean Sensor
Open cover A and remove the transfer unit
temporarily. Wipe the transparent plastic
window at the back of the transfer unit with
a soft cloth, then reinstall the transfer unit.
Close cover A to clear this error.
If the error still remains, replace the transfer
unit with a new one.
Collate was disabled
Printing by specifying the number of copies
is no longer possible due to a lack of memory
(RAM) or free disk space on the optional
Hard Disk Drive. If this error occurs, print
only one copy at a time.
To clear this error, select Clear Warning
from the control panel’s Reset Menu. For
instruction about accessing the control panel
menus, see “How to access the control panel
menus.”
C Toner Low
See “XXXX Toner Low.”
C Toner Out
See “XXXX Toner Out.”
Duplex Mem Overflow
There is not enough memory for duplex
printing. The printer prints only on the front
and ejects the paper. To clear this error,
follow the instructions below.
If Off is selected as the Auto Cont setting on
the control panel’s Setup Menu, press N
Start/Stop to print on the back of the next
sheet, or press the q Job Cancel button to
cancel the print job.
If On is selected as the Auto Cont setting on
the control panel’s Setup Menu, printing
continues automatically after a certain
period of time.
Face Down Full
The output tray is full of printouts, and the
printer has stopped printing. Remove the
printouts from the output tray, and press the
N Start/Stop
button to continue printing.
The output tray can hold up to 250 sheets.
Form Data Canceled
Unable to store form overlay data on the
printer’s optional Hard Disk Drive. Either
the drive is full, or the maximum number of
form overlay files has been reached. Delete
any form overlay files you no longer need,
then try storing the new overlay again.
To clear this error, select Clear Warning
from the control panel’s Reset Menu. For
instruction about accessing the control panel
menus, see “How to access the control panel
menus.”
Form Feed
Hold down the N Start/Stop button for more
than two seconds when the printer is offline
to print the data that remains in the printer.
Format Error ROM A
An unformatted ROM module has been
inserted. If the ROM module has been
formatted, but is still unreadable, format it
again. If the ROM is still unreadable after
reformatting, take the module to your dealer
for repair or replacement.
To clear this error, either press the N
Start/Stop
button or turn off the printer and
remove the ROM module.