Epson AcuLaser C4000 - Printer Parts

(8/22)
EPSON AcuLaser C4000 Quick Reference
Manual Feed xxx
The manual feed mode is specified for the
current print job. Make sure the paper size
indicated by xxx is loaded, then press the N
Start/Stop
button.
For details on the manual feed mode, see
“Manually feeding paper” in the Reference
Guide.
Mem Overflow
The printer has insufficient memory to
execute the current task. Press the N
Start/Stop
button on the control panel to
resume printing. Or press the q Job Cancel
button to cancel the print job. To prevent this
problem from happening again, decrease the
printing resolution or add more memory to
your printer as described in “Memory
Modules” in the Reference Guide.
Menus Locked
This message appears if you try to change
the printer’s settings through the control
panel when the buttons are locked. You can
unlock them by using the EPSON WinAssist
or WebAssist utility. Refer to the
Administrator’s Guide for information.
M Toner Cart Out
See “XXXX Toner Cart Out.”
M Toner Low
See “XXXX Toner Low.”
M Toner Out
See “XXXX Toner Out.”
Need Memory
The printer has insufficient memory to
complete the current print job. Cancel
printing by deleting it from the print queue
on your computer, or by pressing the q Job
Cancel button on the printer.
To clear this error message, select Clear
Warning from the control panel’s Reset
Menu. For instruction about accessing the
control panel menus, see “How to access the
control panel menus.”
To prevent this problem from happening
again, add more memory to your printer as
described in “Memory Modules” in the
Reference Guide.
Offline
The printer is not ready to print. Press the N
Start/Stop
button.
Optional RAM Error
The read/write error occurs when the
printer is checking the optional memory
module in the memory slot S1. The access
speed of the memory module is too slow or
the memory module might be broken.
To clear this error, turn the printer off and
remove the optional memory module, then
turn the printer on.
Paper Out XXX YYY
There is no paper in the specified paper
source (XXX). Load paper of the indicated
size (YYY) into the paper source.