6. Fasten the left side cover with the two screws.
7. Reconnect the interface cable and power cord and turn the printer on.
To confirm that the option is installed correctly, print a Status Sheet. See “Printing a Configuration
Status Sheet” on page 195.
Note for Windows users:
If EPSON Status Monitor is not installed, you have to make settings manually in the printer driver. See
“Making Optional Settings” on page 217.
Note for Macintosh users:
When you have attached or removed printer options, you need to delete the printer using Print & Fax
(for Mac OS X 10.5) or Print Setup Utility (for Mac OS X 10.4 or below), and then re-register the
printer.
Removing a memory module
w
Warning:
Be careful when working inside the printer as some components are sharp and may cause injury.
c
Caution:
Before you remove a memory module, be sure to discharge any static electricity by touching a
grounded piece of metal. Otherwise, you may damage static-sensitive components.
Perform the installation procedure in reverse.
EPSON AcuLaser C9200 Series User's Guide
Installing Options 153
To Next Page
Loading...
