32
3. Attach the 3-axis adjustment unit to the wall mount.
• Decide which position you want to use for installing the 3-axis adjustment unit.
Mount it at the stamp when the image is less than 75 inches (diagonally), or at the stamp
when the projected image is 75 inches or more (diagonally).
• Tighten the M4 × 12 mm hexagon socket head cap bolts (×4) supplied to install the 3-axis
adjustment unit.
: Less than 75 inches
: 75 inches or more
M4 × 12 mm hexagon
socket head cap bolts
Spring washer
Washer
When the diagonal image is less than 75 inches
When the diagonal image is 75 inches or more
Bolt installation positions
To Next Page
Loading...
