Epson C31CE94061N - Page 62

62
Extra lower space reduction
 Disabled (default setting)
 Enabled
Line space reduction rate
 Not reduced (default setting)
 Reduce 25%
 Reduce 50%
 Reduce 75%
Line feed reduction rate
 Not reduced (default setting)
 Reduce 25%
 Reduce 50%
 Reduce 75%
Amount of reduction in character height
 Not reduced (default setting)
 Reduce 25%
 Reduce 50%
 Reduce 75%
Amount of reduction in barcode height
 Not reduced (default setting)
 Reduce 25%
 Reduce 50%
 Reduce 75%
Amount of top margin by backfeed
Selectable from levels 15 mm ~ 2mm (0.5 mm interval)
Default setting: level 15 mm
 Remove all ejected paper before printing with backfeed.
 Disable the automatic top logo setting when enabling backfeed.
 You cannot use backfeed in the following cases even if you have enabled backfeed.
 Immediately after auto cutting while the cover is closed.
 While the self-test is in progress.
 If setting a top margin of 5 mm {0.2"} or less, confirm that no errors occur in your environment of
usage. Usage in a hot and humid environment or usage of paper that curls easily may increase
the risk of paper jams.
 When implementing a backfeed, rubbing smears may occur due to slack in the paper. We
recommend using thermal paper with high rub resistance.