Epson C31CE94061N - Page 64

64
Command execution during offline
 Enabled
 Disabled (default settings)
Character code table defaults
Selectable from 43 pages including user defined page
Initial setting: PC437: USA, Standard Europe
International character defaults
Selectable from 18 sets
Initial setting: USA
Font A auto replacement
 Does not replace (default setting)
 Font B
Font B auto replacement
 Does not replace (default setting)
 Font A
Print density
Selectable from 70% to 130% (5% increment)
Default setting: 100%
Depending on the paper type, it is recommended to set the print density as shown in the table below for the best
print quality.
Original Paper type Density Print speed
AF50KS-E 85% 13 (300 mm/sec)
KT55FA 100% 14 (350 mm/sec)
KT48FA 100% 13 (300 mm/sec)
F5041(55), F5041(48), P30521, P30523, P31523, P35524 105% 13 (300 mm/sec)
 When the print density level is increased, print speed may be reduced. When printing at a
density of 115% or more and below a room temperature of 15°C, the speed drops to less than
200 mm/sec.
 When setting the print speed to level 14, use customized values to set the print density.