Epson C63, C64, C83, C84 - Housing (Right;Left;Frame), Stacker Assy. Removal

EPSON Stylus C63/64/83/84 Revision A
Disassembly and Assembly Disassembly 13
1.3.1 Housing (Right/Left/Frame), Stacker Assy. removal
o External view
Figure 1-2. Housing (Right/Left/Frame) and Stacker assy. removal
o
Part/Unit that should be removed before removing Housing (Right/Left/
Frame) or Stacker assy..
Non
o Removal procedure
[Housing (Right/Left/Frame) removal]
1) Releasing five hooks by hand/precision screwdriver (-), and remove Housing
(Right).
2) Release one hook of I/F cover by inserting metal scale vertically from the slit on
bottom of Housing (Left), and remove I/F cover.
3) Releasing five hooks by hand/precision screwdriver (-), and remove Housing
(Left)
4) Release five hooks by hand/precision screwdriver (-), and remove Housing
(Frame).
[Stacker assy. removal]
1) Push cut-out portion of Stacker Assy. (left side) by precision screwdriver (-),
and pull Stacker assy. to the front side of the printer.
Housing (Left)
Housing (Frame)
Front side Backside
Stacker assy.
This marking is the hook that should
be removed/installed.
Insert metal scale from this slit, and
release one hook of I/F cover.
Housing (Right)
1
2
3 4
5
1
2
3
4
5
Damper
This marking is the hook portion for
Housing cover (Right/Left) and the
order of assembling.
1
This marking is more careful hooks
in assembling/disassembling
This hook is not only the right
side but also the left side.
C A U T I O N
o Do not damage hooks by hand/precision screwdriver (-) in
removing Housing (Right/Left) & Stacker assy..
o Do not tilt the printer too much when Housing (Right/Left/
Frame) is removed by hand/precision screwdriver (-). This is
because ink may possible flow if the cap is not covered by
the Print head. (CR is out of the home position)
o When assembling Housing (Right/Left/Frame) or Stacker
assy. to printer mechanism,
n Hook five ribs for securing Housing cover (Right/Left)
to Housing (Right/Left) in the order indicated in the
figure.
n Make sure that hooks/protrusions of Housing (Right/
Left/Frame), Stacker assy., SW bottom and Panel board
is correctly fixed to Housing (Frame/Lower).
n Make sure that there is not the clearance between
Housing (Right/Left/Frame) and Housing (Lower).
n Make sure that damper for Stacker assy. is correctly
installed to the Housing (Lower).