Epson C63, C64, C83, C84 - Page 44

EPSON Stylus C63/64/83/84 Revision A
Maintenance Overview 44
Figure 3-4. Lubrication point 1
4
<Lubrication point>
• Lubricate G-58 along CR guide parts of
[FRAME MAIN] on 4 position by using
Frame main lubrication fixture. (Figure
3-7)
<Lubrication type>
•G-58
<Lubrication amount>
• Quantity for each position is 100mg.
• Length of G-58 spread is 350mm. (From
Paper Guide Front to Slider Cap hook)
• Wide of G-58 spread is 2mm.
• Use clean Cotton stick to avoid
dirt on G-58.
• Be careful when rubbing the
grease, don’t drop or dirt the
grease to other parts.
5
<Lubrication point>
• Lubricate [GROUNDING SPRING
ROLLER PF] touch side toof [ROLLER
PF]. (Refer to Figure 3-8.)
<Lubrication type>
•G-58
<Lubrication amount>
• F1 x 0.5Fof [ROLLER PF].
• Don’t spread G-58 to other parts.
• G-58 must spread out and touch
to [ROLLER PF] and
[GRANDING SPRING PF].
6
<Lubrication point>
• Lubricate G-26 to center of cam [LEVER
PAPER RETURN]. (Refer to Figure 3-9.)
<Lubrication type>
•G-26
<Lubrication amount>
• F1 x 1mm
• Make sure G-26 doesn’t spread
to other parts.
Table 3-2. Lubrication point
No. Lubrication type/point Remarks
7
<Lubrication point>
• Lubricate G-58 around small circle of
[PULLEY EJECT DRIVE ; B]. (Refer to
Figure 3-10.)
<Lubrication type>
•G-58
<Lubrication amount>
• F1 mm x 2 position
• Don’t spread G-58 to other parts.
8
<Lubrication point>
• Lubricate G-58 onto U-shape of
[HOLDER IDLE ROLLER] on 2
positions. (Refer to Figure 3-11.)
<Lubrication type>
•G-58
<Lubrication amount>
• F1 x 1 circle
• G-58 shouldn’t spread out to
[MOTER ASSY PF] Pinion
surface, and [TIMING BELT].
Table 3-2. Lubrication point
No. Lubrication type/point Remarks
G-58 Ø1mm X 2