Epson DLQ-3500 - Plugging in the Printer

Setting Up the Printer
15
1-5 Plugging in the Printer
Follow these steps to plug in the printer:
1. Make sure the printer is turned off. The printer is off when
the power switch is pressed down to the ❍ side.
2. Check the label on the back of the printer to make sure the
voltage required by the printer matches that of your electrical
outlet. Also make sure the shape of the plug on your printer’s
power cord matches the shape of your electrical outlet.
c
Caution:
It is not possible to change the printer’s voltage. If the rated
voltage on the printer and your outlet voltage do not match,
contact your dealer for assistance. Do not plug in the power
cord.
3. If the power cord is not attached to the printer, plug the
appropriate end into the AC inlet on the back of the printer.
4. Plug the power cord into a properly grounded electrical
outlet.
OFF