Epson DM-D500 - Page 19

DM-D500 Installation Guide 17
English
5. Peel the backing off of one side of the Velcro tapes, and attach
the tapes to both faces of the fixing plate. See the table below to
find the attaching position for Velcro tapes and the display for
your particular printer. (The positioning numbers of Velcro
tapes on the fixing plate are shown in illustrations 39 and
40.)
6. Peel off the backing on the other side of the Velcro tapes, and
stick the fixing plate where you want it.
7. Connect the cable for the display to the DC connector on the
TM printer (UB-S09) until you feel it click as shown in
illustration 41. Store any excess cable in the TM printer, if
necessary.
CAUTION:
Do not connect this connector to an ordinary telephone line.
Printer type Positioning number of
Velcro tape attachment
Attaching position for display
(seen from the front of the printer)
TM-T88II 1 to 9 and 11 Right side
1 to 11 Left side
TM-U210/U230/T90/L90 1 to 11 Both sides
7
9
11
10
8
6
40
4
2
5
39
3
1
41
TM-T88II printer with the UB-S09 installed