DM-D500 Installation Guide 3
English
❏ TM-U950 printer. You can attach the DM-D500 to the TM-U950
printer using the “DM-D pole unit for TM printers (Type
A)”
(DP-502). (See page
7.)
❏ TM-H6000 series and TM-U675 printers. You can attach the
DM-D500 to TM-H6000 series and TM-U675 printers using the
“DM-D pole unit for TM printers (Type
A)” (DP-502). (See
page
9.)
❏ TM-T88II, TM-U210, TM-U230, TM-T90, and TM-L90 printers.
You can attach the DM-D500 to these printers using the “DM-D
pole unit for TM printers” (DP-505). (See page
14.)
❏ Other TM printers. You can attach the DM-D500 using the
“DM-D pole unit for TM printers (Type
A)” (DP-502) and
Velcro tapes or screws. (See page
18.)
❏ DM-D stand. You can attach the DM-D500 directly to the
DM-D stand using the “DM-D stand unit for DM-D500”
(DP-501). When using the DM-D stand, an optional power
supply unit (PS-180) is required. Also, if you want to raise the
height of the DM-D500, an optional extension support unit
(DP-105) is required. (See page
21.)
Precautions When Connecting to a TM Printer
Before the DM-D500 is connected to a TM printer, check the serial
number on the label affixed to the rear or bottom of the TM printer.
If the serial number is one of the numbers listed in the following
table, the printer can be connected to the DM-D500 without an
additional board. If the serial number is not listed in the table, the
DM-D500 requires the latest model of the UB-S01 board (Part code:
C8233610200).
To Next Page
Loading...
Need help?
General
