Epson DM-D500 - Attaching to Other TM Printers

18 DM-D500 Installation Guide
English
8. Place the TM printer on the fixing plate. (See the table below for
the mounting position for each TM printer.)
Note:
Place the TM-U230 printer as shown in
illustration 42. (Do not place it vertically.)
9. Connect the power supply to the TM printer.
Assembling using screws
1. Follow steps 1 to 4 in “Assembling using Velcro tapes.”
2. Secure the fixing plate where you want it
with the fixing screws as shown in
illustration 43.
3. Follow steps 7 to 9 in “Assembling using Velcro tapes.”
Attaching to Other TM Printers
When using with other TM printers, the DM-D500 can be attached
to a desk or other surface using the “DM-D pole unit for TM
printers (Type
A)” (DP-502) and screws or Velcro tapes.
Printer type Mounting positions for TM printers
TM-T88II Set the printer so that no rubber foot on the rear side of the
printer is placed on the Velcro tape.
TM-U210/U230/T90/L90 Set the printer so that no rubber foot on the rear side of the
printer is placed on the Velcro tape.
Set the printer so that the iron plate on the rear side of the
printer is placed on the Velcro tapes.
42
43